To output a program, simply press the "PROG MEM" key, then F5 "ID DIR", then "DATA IN/OUT", then F3 "OUTPUT".I have try this setup that you was recomend me to use, and i could send programs from Pc to Maho, but not from Maho to Pc? I was use Hyperterminal, and when i have send the program i have to push Ctrl+D and then the machine start to recieve it. Could i have folowing setup to Hyperterminal? To output a program, simply press the "PROG MEM" key, then F5 "ID DIR", then "DATA IN/OUT", then F3 "OUTPUT".Thanks for your help, i will try this cable and setup on monday. To output a program, simply press the "PROG MEM" key, then F5 "ID DIR", then "DATA IN/OUT", then F3 "OUTPUT". It requiers special sofware and setup from DMG. You cannot use DNC mode with serial communication. You must also make a 3 wire cable like this:Ĭonstant N770 must be set to "0". Besides software handshake is so much simpler, and you only need a 3 wire cable, so I will only comment on the 3 wire method.įirst check your machine constants, they should look like this: I never use hardware handshaking on the 432 CNC, because it can be quite difficult to get it to work reliably, if you get it to work at all. It is fairly expensive and is not nessessary for only 1 PC per machine. Does anyone now anything about this problem, or have any tip?įor communication software we use Multi DNC. And when the 5th "EQ" has been send to pc, Was sending "EQ" 5 times with about 5 seconds between each other,like it I was thinking if the program have to start with any character to start recieve the file i try to send?Īnd if i tried to send data away from the machine to pc, the machine only At the same time when i click send, when i try to send a program from the pc i got the error code comes up on the machine. Then i could see that some information be sent from the pc to the machine. So i was install a instrument (line listener) between the serial cable, and I got the same error code (D84 i think it was) for data input and output, the error code stands for "waiting to long". I have tried to connect the machine (Maho MH 600E - CNC432) to my pc today, but it did not go so well.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |